Server Cannot obtain a LOCK ressource at this time...

VBourdages

Hi,

I am using SQL toolkit, (From SQL Bundle 5.3.2.0), to do synchronization between two database. When there is not a lot of record to synch, everything work just fine. But if there is a big update to synch... I always getting this error messsage:

Error during replication: The SQL Server cannot obtain a LOCK resource at this time. Rerun your statement when there are fewer active users or ask the system administrator to check the SQL server lock and memory configuration.

Please Help!
Thanks !

chris.buckingham

This error occurs when there are not enough system locks to complete the current command. SQL Server then attempts to obtain a LOCK block to represent and control the desired lock. When dynamically configured, the lock limit is determined by the available memory. When statically configured, the lock limit is determined by the sp_configure setting.

If you continue to encounter this problem, make sure your statistics are up to date, you have sufficient indexes to run your query efficiently, and that the transaction isolation level for your application is not more restrictive than necessary.

Action
Either execute the command again when activity on the server is low, or have the system administrator increase the number of locks by executing sp_configure from the master database.

To view the current configuration:

sp_configure locks
GO

This reports the minimum, maximum, current run, and configuration values. To increase the number of locks, run sp_configure again, specifying the number of locks to be configured. For example, to configure 10,000 locks:

sp_configure locks, 10000
GO
RECONFIGURE WITH OVERRIDE
GO

Stop and restart Microsoft® SQL Serverâ„¢ so the changes can take effect. Locks are allocated at system startup.

If the number of locks cannot be increased at the current time, and the single action requires more locks than the server is currently configured for, you may be able to reduce the number of locks required for the operation. For example, try the following:

For large UPDATE statements, break the updates into smaller units that will affect only a subset of records at a time. For example, you could use the primary key, changing the single UPDATE statement from:
UPDATE employees
SET salary = salary * 1.05
WHERE employee_id BETWEEN 1000 AND 9999
GO

to several UPDATE statements:

UPDATE employees
SET salary = salary * 1.05
WHERE employee_id BETWEEN 1000 AND 4999
GO
UPDATE employees
SET salary = salary * 1.05
WHERE employee_id BETWEEN 5000 AND 9999
GO

For a maintenance type of task or for a global update, consider putting the database into single-user mode (if it is feasible to keep other users out of the database). Single-user mode does not set locks, so you will not run out of locks, and the operation will run somewhat faster (because you save the locking overhead).


For a large bulk copy operation, the entire operation is treated as a single transaction. When you use the batch parameter (-b), the bcp utility will treat the operation in small transactions with the number of rows specified. At the end of each small transaction, the system resources held by that transaction are freed, so fewer locks are needed.

VBourdages

Thank you for the answer, I will test your recommendation.


Great support team !