Running Synchronise first time

SharonSharon Posts: 2
Hi, I am running the synchronise for the first time and do not want it to sync all tables. We have some audit tables, that I wish to be ignored, is there anyway I can force it to run just using the selected tables on the very first sync?
Thanks
Sharon

Comments

  • Brian DonahueBrian Donahue Posts: 6,590 New member
    Hello Sharon,

    Your best bet is to use saved project files. Set up a comparison with the tables and columns that you want to compare, perform the comparison, and then save the project from the file menu.

    Then the next time that you want to use the same table and column settings, you can load the project again from the file menu and rerun the comparison.
This discussion has been closed.